1 Housing
2 Temperature controller with LED display
3 Hose pumps for condensate or dosing (optional)
4 Condensate output
5 Mounting bracket
6 Sample gas connections of the heat exchangers
7 Cable entries for the electrical connection cables
(permanently connected)
The SCC-C gas cooler is used in analysis
technology to lower the dew point of humid
gases to prevent condensation in the analyzer.
The stable, low gas outlet dew point minimizes
water vapor cross-sensitivity and volumetric
errors.
Intended use
The SCC-C sample gas cooler is designed for cooling the sample
gas, separating the condensate and discharging the condensate.
Optionally, the SCC-C can also be used for reagent dosing.
Any other use is not approved.
The intended use also includes taking note of this operating
instruction.
Versions
The specifications on the type plate are decisive for the version
of the sample gas cooler.
Standard version
The standard version of the sample gas cooler is designed for
installation in non-hazardous areas.
The sample gas cooler complies with EN 61010 Part 1 “Safety
requirements for electrical equipment for measurement, control,
and laboratory use”.
Intended purpose of the sample gas cooler
The SCC-C sample gas cooler is a component of the sample gas
conditioning system in an analyzer system.
In the sample gas cooler, the humid sample gas is cooled to such
an extent that the temperature does not down-scale the dew
point at any subsequent point in the analyzer system and
therefore no condensate can penetrate the gas analyzer.
Functions of the sample gas cooler
The SCC-C sample gas cooler has the following functions:
• cooling of the sample gas,
• separation of the condensate and
• condensate discharge.
For certain measuring functions, the dew point of the sample
gas must be kept constant in order to eliminate the influence of
water vapor on the measurement result. In these cases, the
constant water vapor content is considered during calibration by
the test gas supply upstream of the sample gas cooler.
Use in conjunction with the sample gas feeder unit
SCC-F
The SCC-C sample gas cooler can be used in conjunction with the
SCC-F sample gas feeder unit.
The SCC-F sample gas feeder unit has the following functions:
• condensate monitoring,
• sample gas feed and
• flow adjustment and monitoring.
For information on the SCC-F sample gas feeder unit, refer to
the operating instructions OI/SCC-F.
Note
The SCC-F sample gas conveying unit is not available in an
explosion protected version in category 3G.
Constant outlet dew point
1 or 2 gas paths
Heat exchanger made from glass, PVDF or stainless steel, exchangeable without tools
Corrosion-resistant gas lines
High pressure design up to 1 MPa (10 bar)
Temperature controller and display
Suitable for ambient temperatures up to 50 °C
Compact surface-mounting housing (width 1/2 19 inches, 6 height units)
System solutions in connection with the SCC-F sample gas feed unit
Suitable for use in measuring equipment conforming with 17th BImSchV (German Federal Immission Protection Law)
Explosion-proof versions with ATEX and CSA certifications
All new products and surplus products of the industrial intelligence industry, as well as the discontinued products of the original manufacturers. We are not an authorized distributor or representative of any of the above manufacturers (except for brand authorization). The trademarks, brand names and brands appearing in this agreement are the property of their respective manufacturers.
COPYRIGHT© 2003-2025 Copyrighted
Phone(WeChat/Whatsapp)
+086-181 4410 0983
No 1134 Jimei North Road,
Hong Kong Office:
Guan Tang District, Hong Kong,